Quote:
Originally Posted by bdebde
It seemed the older firmware would start out at higher % of throttle with wider neutral zone, but it seems like the new firmware starts at 0% throttle no matter what the neutral zone is. Also, setting the neutral too narrow (6% on mine) would sometimes not allow reverse to engage, or forward after using reverse.
|
Funny you should mention that....I had the same issues yesterday too. I would engage rev. and then nothing...I will reset mine to 12% and see what happens.
1. MBX-6 T8 1900KV, RX8 ON 4S
2. MBX-5T 1520, MMM ON 5S
3. MBX-5 ONROAD CONVERSION 1515, MMM ON 5S
4. MRX-3 ON ROAD CONVERSION 1512, MMM ON 6S
5. TEN T 2650 T8, MMP ON 3S
Threaded Mode
