HPI Nitro MT brushless conversion, where do I start?

[bdebde]

Yes I made the mount, bent it up out of a flat piece of aluminum. Running 3s lipo. Tried the 5700, but it ran too hot, switched to the 4600 and it worked out better. I ran 12/52 gearing, about 45mph with the 4600 and about 55mph with the 5700. The servo is actually mounted to the upper deck, it is an hpi upgrade for the MT2 (may fit the MT). I will see if I can find some more pics tommorow. I used industrial wire duct for the battery holder, with a gorilla strap. PM me and I can send some of the stuff for the battery holder.