Center motor mount for hyper 8.5?

Will the motor mount in Mikes store fit a 8.5? I know it's to the side, but it seems like the only quick way to make this happen.

[tc3_racer_001]

see my thread in the buggy forum. :) (it does with some parts from the h8 diff)

Okay, this is my first time using calipers, not sure if it's right...

for the mount holes I have 34.70 front to back, 21.15 side to side, 40.74 criss cross.

Originally Posted by brushlessboy16

could i get measurements of the center-to-center distance of the center diff mount holes (where it attaches to the chassis)

also the distancece between the inside of the front and rear center diff mounts

[brushlessboy16]

hmmm 34.7? and 21.25. were your calipers zeroed? kind of odd

Should they all be like 35.5 and 21.25, or should they all be whole number?

[brushlessboy16]

i would expect a hole number or half, quarter etc.. just not .4 :D

[Arct1k]

Easier to measure the outside and inside of the holes and then split the difference rather than guessing the middle... :)

[brushlessboy16]

chris you have a hyperst, you can measure it ;)

Originally Posted by tc3_racer_001

see my thread in the buggy forum. :) (it does with some parts from the h8 diff)

What parts should I order?

[Arct1k]

I don't have calipers - sorry

[BL_RV0]

I've got a Hyper ST and calipers, just let me know how you want me to measure them, I'd be happy to.

[Arct1k]

From the bottom the top and bottom of the car we need the inside and outside measurements of the diff mount screws - length and width

Also height of diff mount - inc and excluding stiffner plate

Also height from bottom of diff mount to bearing and from bearing to top of diff mount.

[brushlessboy16]

the center to center holes, lengthwise and width please :D

[tom255]

Its not just so simple, take measures and draw, cut detail. They need generate G-code check that G-code and then try to mill. Actualy best to give whole car to specialist and explain that you need

[Arct1k]

If this goes ahead I'm happy to lend my car to mike but he already has a hyper mount so I believe will be able to do this simply by adjusting his existing design...