newbie tekno-rc revo owner...

[magman]

Originally Posted by dmeylman

i have mmm esc with 5s...is it ok to use "auto" on voltage cutoff setup???

Most of us here use custom selection and run anywhere from 3.1v/cell to 3.3 v/cell. I run 3.2 v/cell as a little insurance

Originally Posted by magman

Most of us here use custom selection and run anywhere from 3.1v/cell to 3.3 v/cell. I run 3.2 v/cell as a little insurance

thanks, i'll try that...

Originally Posted by magman

Most of us here use custom selection and run anywhere from 3.1v/cell to 3.3 v/cell. I run 3.2 v/cell as a little insurance

the lowest i could get from castlelink software using custom is 4.0V...
is that means per cell or total v for the whole battery...
pls. help...

Originally Posted by dmeylman

the lowest i could get from castlelink software using custom is 4.0V...
is that means per cell or total v for the whole battery...
pls. help...

that would be the total voltage of the pack, I go with 3.3 vpc, I have noticed that this is about the time the vehicle will start to slow down

Originally Posted by azjc

that would be the total voltage of the pack, I go with 3.3 vpc, I have noticed that this is about the time the vehicle will start to slow down

so if i have a 5s pack, my cutoff should be about 16v...