using the RS pro in a 1/8 converson?

[whitrzac]

one little thing I noticed, you can't re calibrate the esc when using a external BEC....it just sits there trying to find neutral.

[crazyjr]

Originally Posted by whitrzac

one little thing I noticed, you can't re calibrate the esc when using a external BEC....it just sits there trying to find neutral.

for programming, you need to reattach the red wire and use a 2s pack

[whitrzac]

Originally Posted by crazyjr

for programming, you need to reattach the red wire and use a 2s pack

lil late now...

the RSpro is being sold for an RX8

[whitrzac]

Originally Posted by whitrzac

lil late now...

the RSpro is being sold for an RX8

since everyone seems to have an "good" esc at the LHS, how would an RSpro fair with a tekin truggy 2250 motor in an e-maxx? with the usual bec/caps/fan...

[TekinTeamMgr]

I'd get an RX8. The RS Pro is not intended for that application. I always recomend the right esc for the job.

However that being said I'm sure it'd be ok. Making sure that it's setup properly with low timing and in Dual mode. Proper caps,etc.