Hobbywing 150A Ezrun esc review

[nusti]

thanks, just sent the mail again. I hope they will reply.

[superek4]

Managed to get a latest version of hobbywing 150 esc tested in my 3rd race.

1st heat software problem car has max drag brake, managed to reset.

2nd heat batt died, I used a 4s 5000 zippy set 4s manually on d esc but still one cell died. Dunno izzit batt problem or esc

3rd heat completed with no problem

At the Main batt pop out becoz it was a 6s n was not secured properly, fix n tried to run then found out d switch was cut by my spur gear. Tried to connect the black n red wire but can't start d esc. Din want to try d white wire in case the esc gets burnt.

So far I m ok with d esc change all setting except punch, esc ran cool. Need to find out how to undo the drag brake though.

[littlegiant]

Originally Posted by superek4

Managed to get a latest version of hobbywing 150 esc tested in my 3rd race.

1st heat software problem car has max drag brake, managed to reset.

2nd heat batt died, I used a 4s 5000 zippy set 4s manually on d esc but still one cell died. Dunno izzit batt problem or esc

3rd heat completed with no problem

At the Main batt pop out becoz it was a 6s n was not secured properly, fix n tried to run then found out d switch was cut by my spur gear. Tried to connect the black n red wire but can't start d esc. Din want to try d white wire in case the esc gets burnt.

So far I m ok with d esc change all setting except punch, esc ran cool. Need to find out how to undo the drag brake though.

Did you play around with the timing? how did you get the lastest firmware version?