Pay-It-Forward 2009

[Metallover]

Originally Posted by brushlessboy16

another member was looking for 8ight parts IIRC, check the "do you have this is your tool box" thread

That was me, and I don't need them anymore.

I do need stock e-revo/e-maxx electronics. PM me and I'll give you my situation.

[Krawlin]

Just got my spool in the mail from E-Revonut! In great condition, and thanks for giving me a good deal on it! Fast shipping too!

I need a plastic stampede chassis and braces and a brushed system to rebuild an old stampede so my stepdad can have something to drive.

[brushlessboy16]

I have an Rcm Emaxx Idler gear and a full set of front/rear grey bulkheads for maxx trucks. Received them wayy after i had sold my emaxx and have now use for them. No need for pics really, they are in like new condition- the Idler includes rubber sealed bearings.

Anybody have a bottom plastic shock end for a Losi 8? Broke one the other day and the LHS is out of them and the "kit" deal it comes with is a bunch of other parts I dont need and its $10.

[BL_RV0]

Originally Posted by Fast5sRevo88

I need a plastic stampede chassis and braces and a brushed system to rebuild an old stampede so my stepdad can have something to drive.

I've got a pede chassis with braces, a 20t titan and a novak rooster esc I'd be happy to PIF. The RX plug on the rooster is cut off, has about a 2" lead on it. The battery wires are also cut short, about a 1" lead each. Motor wires are fine, and theswitch is still intact. Will need all connectors though.

[rawfuls]

I need some 3905 axle carriers.
I've got a set of 3906 CVD's if I get those 3905 axle carriers.

Need some new driveshafts ^_^

[johndeerekid]

hello everyone, im looking for any clodbuster rims or stock e-maxx driveshafts or an e-maxx tranny(willing to pay shipping for all but cant buy im low on green) for an all custom crawler project im doing. thanks -Wes

[trev3813]

Anyone have a dogbone, about 3 and 3/8 inch long?

[RUSTY XL-5]

Originally Posted by trev3813

Anyone have a dogbone, about 3 and 3/8 inch long?

I have 2 just a smidge over 3.5 inches long. I used to use them on my rusty.

[trev3813]

I snaped one of mine on my rustler. What'd you want for em?

[RUSTY XL-5]

Originally Posted by trev3813

I snaped one of mine on my rustler. What'd you want for em?

I'll PM you.

[JThiessen]

Originally Posted by brushlessboy16

I have an Rcm Emaxx Idler gear and a full set of front/rear grey bulkheads for maxx trucks. Received them wayy after i had sold my emaxx and have now use for them. No need for pics really, they are in like new condition- the Idler includes rubber sealed bearings.

Sending you a PM....My B'in law is in need of some bulks. and at some point, that idler (if I can get him to upgrade from the Novak.....)

[whitrzac]

does anyone have a motor(s) that would work in an e-maxx??

[RUSTY XL-5]

See my add, I'll trade for 32P 3mm pinions and jato spurs.

http://www.rc-monster.com/forum/show...667#post284667