 |
|
|
|
|
|
 |
 |
 |
|
 |
|
(#17)
|
|
Check out my huge box!
Offline
Posts: 11,935
Join Date: Aug 2007
Location: Slidell, LA
|
06.05.2009, 12:51 AM
The wiring is not permanent, just threw it in there to tr out my setup. I had to laugh when I saw your wires wrapped around the motor leads! Only with spectrum would that work!
What do the diffs have in them stock? Grease? feels like it. I need to move the MM over and back a bit, and reroute the signal wires. I will leave the rx on the servo, as I like the antenna routing there. Plus I can make a wire clamp for the signal wire next to the rx, using those 2 bolt holes. |
|
|
|
 |
 |
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Threaded Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2026, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
