Quote:
Originally Posted by sikeston34m
You could use a servo splitter lead on the escs, and a servo tester knob.
This will allow you control of the blades, but it won't be on the controller.
The AXI 4130's won't draw much amperage unless you're really cutting some tall stuff.
The Quark 65 should handle it fine if you decide to use it.
|
Good to know, I figured I would give it a try before I bought anything else.
Heres a pic of the motors that Sike is trading me. I will use the 2 4130/20 motors for the blades, and I have a matching 2826/12 already to pair with the one in the pic for the drive system
Threaded Mode
