Who would be interested in 17mm adapters for the crt.5?!?!?

[nougat]

+1

I would be interested as well if the price is right. It would be great to have all my 1/8th buggy wheels and tires available for my crt.5.

I think it's really important that they extend the wheel hubs out as wide as possible to take into account 0 offset buggy wheels, especially for those of us that use Mike's conversion kit with the extra long chassis. I currently use HPI 1/10 truck wheels because they are offset quite a bit and it gives the crt.5 a wider stance. I'm not sure I would give up a wider stance in exchange for buggy tires.

[R00ST]

Dont worry Nougat Ive got it covered. I have two crt.5's both with Mikes chassis and its dying for some width.

I told him I want 1" of extension PER side (total of two inces wider). This would make it another almost half inch wider than running "half" offset wheels. So even with 0 offset buggy wheels it will be wide. I didnt want to go any more than 1" on them as I think the bearings/axles will wear prematurely with that much leverage on them.

[nougat]

Originally Posted by R00ST

Dont worry Nougat Ive got it covered. I have two crt.5's both with Mikes chassis and its dying for some width.

I told him I want 1" of extension PER side (total of two inces wider). This would make it another almost half inch wider than running "half" offset wheels. So even with 0 offset buggy wheels it will be wide. I didnt want to go any more than 1" on them as I think the bearings/axles will wear prematurely with that much leverage on them.

Nice!

Keep us updated on them. I just picked up mt .5 today and want to put some buggy wheels on it.