My bl project

[coolhandcountry]

The back and front are not different unless it is extended. What kind of cvds are you using to? RD logics are shorter than others.

[mmdooley]

Coolhand I dont know what's going on i could not pull up your post after refreshing 5 or6 times.??? My center drive shafts that come from the trans. and goes to the rearends. one is longer than the other "on the stock setup". I used the longest one to go from my trans. to the frontend and the one that came with the chasiss goes from the trans. to the rear.

dooley, have you screwed your piviot balls in all the way?

[mmdooley]

Yes, removed lock nuts & screwed pivot balls all the way in.

Will the cvds fall out at high speed being that close to the edge of the cup? If I buy more cvds, aren't they all the same length for a wide maxx?

I got my mip cvds off ebay, for $15 a set. theres some on there where you can buy two sets for $45

[squeeforever]

the rdl cvds are shorter than the rest for some reason. mips, ue's ect. should fit.

[mmdooley]

Yea, but won't they be the same length as the ones I got??

[mmdooley]

Thanks Squee you posted while I was typing. Can anyone measure one of thier cvd's so I can compare to mine? So I will know I have rdl's.

[squeeforever]

well shiny with a boot is rdl.

[coolhandcountry]

160mm from end of axle to end of axle for rd logics.