oh no!! receiver wires ripped out of MMM

[mikey09120]

i did open the case but to castle's instructions. and i never soldered anything. i did remove the switch thogh but that shouldnt affect it. and i believe its my fault because ive heard that the hole where the reciever wires exit out of the case is a tight fit to avoid yanking. in my thread in post #48 you can see that i drilled a hole at the bottom of the MMM case for the reciever wires to exit. but the wires are not taught. they are very loose. and i dont understand how it would be yanked in the middle of a 10mph run?

sorry if im coming off a little strong