CAD Drawing - RC-Monster Forums

		RC-Monster Forums > RC-Monster Area > General Discussion
CAD Drawing

Rate Thread

Prev

Previous Post

Next Post

Next

	(#5)
J57ltr RC-Monster Aluminum Offline Posts: 610 Join Date: Feb 2009 Location: Tomball/ Houston Tx.	07.27.2009, 09:55 PM I'm almost done with the bottom plate but I need the hole sizes, the dim from the length of the rear tab. and can't really read the dims on the rear tab. and what Rad do you want on them? Jeff Attached Thumbnails The Warnings & Cautions discussed in this manual cant cover all possible conditions/situations. It must be understood that common sense and caution are factors which cant be built into this product. Last edited by J57ltr; 07.27.2009 at 10:25 PM.

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is On Forum Rules

Forum Jump

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com