My e-revo brushless edition build

[rawfuls]

I picked up on it awhile ago, when I was on the TRX forums (When I first started RC), they don't bend, they snap, which is why some guys used it, because it would snap instead of bending inside the bulkheads and AArms, and instead of pitchin for a new set of AARms and bulkheads, it'd be easy to remove since it snapped into a couple pieces...
I'll try and see if I can't find a link when I get home.

[mistercrash]

I received my Polymax 5.5 mm bullet connectors from Hobby City this morning. They are big and nice and without wires on them, you need pliers to pull them apart. I am just wondering about that cut out where you solder the wires. I would have preferred a hole instead of a big cut out like that. To get these connectors undone, it would be necessary to pull on the wires so they have to be soldered correctly with a strong bond. I'm afraid these big cut outs limits the surface area where the wires are soldered onto, making that bond between wire and connector weaker. This is just speculation on my part as I haven't installed them. I looked at all my lipos I just redid with Deans and I don't feel like starting over again