What CF sheet to use for 1/8 buggy chassis????

[pb4ugo]

Originally Posted by whitrzac

looks like dragon plate it is then...


just to make sure, I can put the chassis kickup in buy heating it with a heat gun and bending it, right?

While a few on this forum have had luck with that, any composites manufacturer will tell you no and that it has to be molded in. The set epoxy is not a thermoformable material.

[whitrzac]

Originally Posted by pb4ugo

While a few on this forum have had luck with that, any composites manufacturer will tell you no and that it has to be molded in. The set epoxy is not a thermoformable material.

how hard is it to "make" your own CF sheets by using CF fabric??

[rchippie]

Originally Posted by whitrzac

how hard is it to "make" your own CF sheets by using CF fabric??

It would be cheaper to buy the sheet all ready made . Plus if you dont know how do it properly. you will not have a good panel .