New flux broke rear turnbuckle would like to eliminate them. Options?

Originally Posted by Gee

Old thread but I've been browsing the savage forum looking for ideas and came across these that are listed for the XL. I don't own the X only the XL but I thought they used the same carries. Why they have these listed for the XL and not the X I am not sure but just thought I would toss them out there. Looks like a copy of the Atomic ones that were mentioned earlier in the thread.

http://www3.towerhobbies.com/cgi-bin...1&I=LXWSY0&P=K

I've got those carriers. I assumed they would fit too since the Sav Flux is supposed to have the same uprights as the XL. Truck is all in pieces right now so I can swap out the phillips head screws for hex but I should have it all together by the end of the weekend with a few additonal upgrades including the carriers.

I'm not a particularly big fan of Integy either but if the part fits well and holds up then I'll give them credit on this item.

For the front of the truck I'm hoping the servo saver will keep the knuckle from breaking. I also think the turbuckle looks a little thin so I'll be running the Hellfire turnbuckle as well (I'm fine with the steel M5X60mm). Works out well in my E-Sav so I'll run it on this truck as well.