RC-Monster Forums  

Go Back   RC-Monster Forums > RC-Monster Area > General Discussion

Reply
 
Thread Tools Rate Thread Display Modes
Got a 3800mah NiMH pack
Old
  (#1)
HomeGrown
RC-Monster Carbon Fiber
 
HomeGrown's Avatar
 
Offline
Posts: 170
Join Date: Dec 2007
Location: P-Ville, LA
Got a 3800mah NiMH pack - 12.01.2009, 05:48 PM

well i did some trading and i recived a 6 cell Intellect 3800mah NiMh pack.. i got it in the mail today.. well i hooked it up to my charger and it dont beep (Prophet plus charger beeps when it "reads" a battery has been hooked up).. well after doin some voltmeter checking it has 1.6V TOTAL.. is there a way to "Zap" it?.. all the solder joints are fine.. there is 2 or 3 cells that have a voltage lower then 1V.. but i've had cells come back from 0 before but my charger also read that the pack was there when i did those.. i'm aggrevated.. i've been waiting for this pack to run my pede again.. oh and those screws PEDEBASHER!! LOL.. well can this pack be revived? or should i send it back?



BL Pede, Integy aluminum steering linkages, aluminum shock caps, RPM camber links.
Never Replace Always Upgrade!
   
Reply With Quote
Old
  (#2)
brushlessboy16
Im not dark, Im over ripened! xD
 
brushlessboy16's Avatar
 
Offline
Posts: 5,607
Join Date: Sep 2007
Location: Westampton NJ
12.01.2009, 06:05 PM

Nimh lose charge when they sit. run the last bit out of it then peak it- you should be fine.


Benjamin White
R/c Monster Team Driver
Jq the car, LST, Sportweks turmoil pro
Unconventional Techniques, Superior Results
  Send a message via Yahoo to brushlessboy16 Send a message via AIM to brushlessboy16 Send a message via MSN to brushlessboy16  
Reply With Quote
Old
  (#3)
jhautz
RC-Monster Mod
 
jhautz's Avatar
 
Offline
Posts: 4,217
Join Date: Apr 2006
Location: Chicago, IL
12.01.2009, 06:08 PM

Try setting the charger to a lower cell count if you can. Like maybe 1 or 2 cells. That might make it so it detects the pack. Then you can slowly bump the voltage and keep addin cella to the charger setting untill you get the voltage up to a reasonable range.

As far as reviving the pack... I found that a very slow charge and discharge will sometimes bring a seemingly dead pack back to life. Set the charger for the cycleing mode and then charge it at a super low rate like .1amps and then discharge at the same low rate. Do this a few times until you start to see the capacity of the battery come back.

Unfortunatly, thr pnch of thrnpack never rally seemed to recover for me. Once it went dead it might get most of thr capacity back but the punch is pretty weak after that.


I can't decide if its more fun
to make it...
or break it...


Silent...But Deadly


   
Reply With Quote
Old
  (#4)
HomeGrown
RC-Monster Carbon Fiber
 
HomeGrown's Avatar
 
Offline
Posts: 170
Join Date: Dec 2007
Location: P-Ville, LA
12.01.2009, 06:16 PM

Thanks guys.. i've got it figured out.. i "jumped" it.. using a 6V battery and some extra wire to give it a few more volts.. i appreciate the info tho!!

btw my charger dont discharge batteries and it only does 1, 2, and 4 amp charges..

and brushless boy i plugged it into my pede and the esc didn't even turn on..lol thats how dead it was..



BL Pede, Integy aluminum steering linkages, aluminum shock caps, RPM camber links.
Never Replace Always Upgrade!

Last edited by HomeGrown; 12.01.2009 at 06:18 PM.
   
Reply With Quote
Old
  (#5)
rawfuls
roofles.
 
rawfuls's Avatar
 
Offline
Posts: 1,982
Join Date: Oct 2008
Location: Woodland Hills, CA
12.01.2009, 06:54 PM

You can always use a light bulb to discharge..
  Send a message via AIM to rawfuls Send a message via MSN to rawfuls  
Reply With Quote
Old
  (#6)
Bondonutz
Fat Kid Engineering
 
Bondonutz's Avatar
 
Offline
Posts: 3,634
Join Date: Jun 2009
Location: Hot as Hell West Central Coast Florida
12.01.2009, 07:24 PM

Hope you only traded a toe nail clipping for it ?


I retired from RC, now life is all about guns and long range shooting.
   
Reply With Quote
Old
  (#7)
sikeston34m
RC-Monster Brushless
 
sikeston34m's Avatar
 
Offline
Posts: 2,085
Join Date: Sep 2007
12.01.2009, 07:31 PM

Quote:
Originally Posted by Bondonutz View Post
Hope you only traded a toe nail clipping for it ?



You crack me up.
   
Reply With Quote
Old
  (#8)
HomeGrown
RC-Monster Carbon Fiber
 
HomeGrown's Avatar
 
Offline
Posts: 170
Join Date: Dec 2007
Location: P-Ville, LA
12.02.2009, 12:05 AM

Quote:
Originally Posted by Bondonutz View Post
Hope you only traded a toe nail clipping for it ?
No, actually I traded Killzone 2 for ps3 for that pack (6 cell Intellect 3800NiMh) and a VXL pede chassis.. I still have to send him the game..lol i keep forgetting.. i need to before he thinks imma rip him off..



BL Pede, Integy aluminum steering linkages, aluminum shock caps, RPM camber links.
Never Replace Always Upgrade!
   
Reply With Quote
Old
  (#9)
Bondonutz
Fat Kid Engineering
 
Bondonutz's Avatar
 
Offline
Posts: 3,634
Join Date: Jun 2009
Location: Hot as Hell West Central Coast Florida
12.02.2009, 09:27 AM

To send you a pack completely dead is not doing you any favors. I hope the pack can be saved ?


I retired from RC, now life is all about guns and long range shooting.
   
Reply With Quote
Old
  (#10)
HomeGrown
RC-Monster Carbon Fiber
 
HomeGrown's Avatar
 
Offline
Posts: 170
Join Date: Dec 2007
Location: P-Ville, LA
12.02.2009, 10:52 PM

it was saved it runs like a dream too!!



BL Pede, Integy aluminum steering linkages, aluminum shock caps, RPM camber links.
Never Replace Always Upgrade!
   
Reply With Quote
Old
  (#11)
scarletboa
RC-Monster Aluminum
 
scarletboa's Avatar
 
Offline
Posts: 929
Join Date: Mar 2009
Location: Las Vegas NV
12.03.2009, 01:28 AM

Quote:
Originally Posted by HomeGrown View Post
it was saved it runs like a dream too!!

just wait until you try lipo. you can get some nice 2s packs from hc for about $20.


They say a good mechanic only needs 2 tools - WD40 & Duct tape. If it moves, and its not supposed to, duct tape. If it doesn't move, and its supposed to, WD40.
   
Reply With Quote
Old
  (#12)
_paralyzed_
working on a brushless for my wheelchair.....
 
_paralyzed_'s Avatar
 
Offline
Posts: 4,890
Join Date: Mar 2007
Location: minnesnowta
12.03.2009, 01:39 AM

Quote:
Originally Posted by HomeGrown View Post
it was saved it runs like a dream too!!
if I got a nimh pack in that condition I would consider it junk. You may have gotten it to take a charge and work, but for how long will it work? It's lifespan has been seriously shortened by it being discharged that far for any length of time. The longer it sat like that, the more life or "cycles" it lost. Good luck.


_______________________________________

It's "Dr. _paralyzed_" actually. Not like with a PhD, but Doctor like in Dr. Pepper.
   
Reply With Quote
Old
  (#13)
HomeGrown
RC-Monster Carbon Fiber
 
HomeGrown's Avatar
 
Offline
Posts: 170
Join Date: Dec 2007
Location: P-Ville, LA
12.03.2009, 06:44 PM

Quote:
Originally Posted by scarletboa View Post
just wait until you try lipo. you can get some nice 2s packs from hc for about $20.
i plan to run lipo soon hopefully.. I've seen the packs at hc.. and i will be running a Turnigy 2s 5000mah.. soon isnt soon enough tho!



BL Pede, Integy aluminum steering linkages, aluminum shock caps, RPM camber links.
Never Replace Always Upgrade!
   
Reply With Quote
Old
  (#14)
HomeGrown
RC-Monster Carbon Fiber
 
HomeGrown's Avatar
 
Offline
Posts: 170
Join Date: Dec 2007
Location: P-Ville, LA
12.03.2009, 06:48 PM

Quote:
Originally Posted by _paralyzed_ View Post
if I got a nimh pack in that condition I would consider it junk. You may have gotten it to take a charge and work, but for how long will it work? It's lifespan has been seriously shortened by it being discharged that far for any length of time. The longer it sat like that, the more life or "cycles" it lost. Good luck.

see thats you tho.. i dont have the money to just go out and buy new stuff.. thats why its takin me so long to get LiPo stuff.. and by the looks of it its going to take me even longer to go LiPo.. all my money goes towards bills and stuff for my son.. makin $11.50 an hour and having a $1000 dollar house note on top of other bills dont leave me much room to buy anything for my RC.. so i'll take what i have and be happy with it.. i will use this battery till im dis-satisfied with it.. by that time i might have enough money saved to go LiPo but untill then.. i'll take my "junk" battery pack and continue to beat the shit outta my pede with it..

/end-rant.. (no offense)



BL Pede, Integy aluminum steering linkages, aluminum shock caps, RPM camber links.
Never Replace Always Upgrade!
   
Reply With Quote
Old
  (#15)
_paralyzed_
working on a brushless for my wheelchair.....
 
_paralyzed_'s Avatar
 
Offline
Posts: 4,890
Join Date: Mar 2007
Location: minnesnowta
12.04.2009, 11:42 PM

for sure, if it's working for you and you're having fun that's all that matters. I didn't mean to say you have junk, I just wanted to illustrate the point that sitting without a charge is very hard on nimh's, I'm always leary of used batteries


_______________________________________

It's "Dr. _paralyzed_" actually. Not like with a PhD, but Doctor like in Dr. Pepper.
   
Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump







Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com