Project: Savage Flux 5T

[williamg]

I'm running 17-44 and it has a bit of room still so a 16 may even be possible.



Started work on my proline 5b rat body, and test fit a venom motor cycle rider those are in the works

Quickie video taken with my kodak c1013 digital camera

Watch on vimeo for best quality http://vimeo.com/11115163

on you tube http://www.youtube.com/watch?v=FpD_thI6OPo
.
poser shots
Driver figure just tossed in, but will be adjusted and seated with a steering wheel







.

[Semi Pro]

Originally Posted by williamg

I'm running 17-44 and it has a bit of room still so a 16 may even be possible.



Started work on my proline 5b rat body, and test fit a venom motor cycle rider those are in the works

Quickie video taken with my kodak c1013 digital camera

Watch on vimeo for best quality http://vimeo.com/11115163

on you tube http://www.youtube.com/watch?v=FpD_thI6OPo
.
poser shots
Driver figure just tossed in, but will be adjusted and seated with a steering wheel







.

that makes me wish i hadnt sold my savage so much


keep up the good work, i cant wait to see it with the body on

[williamg]

Originally Posted by Semi Pro

that makes me wish i hadnt sold my savage so much
keep up the good work, i cant wait to see it with the body on

Next I need to make a seat and put in the driver

[thzero]

Very nice looking. Looks like what I'm ending up doing with the body.

How did you do the lexan top? I've tried several unsatisfactory methods with heat gun.

[williamg]

Originally Posted by thzero

Very nice looking. Looks like what I'm ending up doing with the body.

How did you do the lexan top? I've tried several unsatisfactory methods with heat gun.

Same here the heat gun was a joke. I ended up just hanging the lexan over the table edge and running a zippo lighter under the bend line. All you need to do is have the part to wide, then trim as it tended to ''shrink'' at the bend sides.

[Nixpus]

THeres quite a bit of motor mount talk in the middle of the thread... so heres my two cent: http://www.rc-monster.com/forum/show...t=20862&page=2

With the mount version two I made the motor is placed under the spur gear (LCG anyone?) and has plenty of room for gearing with a 4465 motor... its simple and easy to make.