Traxxas Slash 4WD Durability???

I wonder if we could raise some other people's interest, if Mike would make a batch of carriers that would fit the Slash, and use Revo bearings. I would imagine 1 set would be costly, but 5 sets might make it reasonable. Especially when the Tekno's are almost 100$ for a set of 4, and they are dogbones, which means they will wear. I could see the interest for these being high.

[sikeston34m]

Originally Posted by asheck

I wonder if we could raise some other people's interest, if Mike would make a batch of carriers that would fit the Slash, and use Revo bearings. I would imagine 1 set would be costly, but 5 sets might make it reasonable. Especially when the Tekno's are almost 100$ for a set of 4, and they are dogbones, which means they will wear. I could see the interest for these being high.

That's a good question. I doubt there's enough material to remove to accomidate the OD of the bearings inside the Tekno version.

If the diff-to-wheel drive shafts are the weak link, upgrades to that portion of the truck would be a hot seller.

The factory center drive shaft is pretty bullet-proof looking already.