Brushless hpi baja rc-monster

[Ryu James]

Originally Posted by thomatrix

I just ordered one too. I know it may be going over board but I have a 2215 and ordered a 2230 + a Lehner 3060 to try out on two bajas.

Excellent thread here btw! Thanks of all the pics and info. Much appreciated.

where are you buying your motors from? particularly where did you buy your lehner?

[thomatrix]

Originally Posted by Ryu James

where are you buying your motors from? particularly where did you buy your lehner?

I buy them straight from the manufacturer:
http://www.lehner-motoren.com/

[thomatrix]

I just received my 2230 from Offshoreelectrics to find out that the measurements given was not correct and that the motor will not fit the car.

Here are the specs
- Given measurements:From this chart on Offshoreelectrics website the length of the 2230 1.5Y is 4.7 inches
http://www.offshoreelectrics.com/neu-motor-chart.htm

- The car with the kit mounted has exactly 4.975 inches of space for a motor. This should leave enough space based on the above mentioned chart...

- The motor that i received is 5.491 inches long :( This includes the little peace of the shaft sticking out the rear of the motor.

Any ideas where I went wrong here?? Should be pretty straight forward.