New Mamba software (beta) posted today

[Pdelcast]

Originally Posted by revo guy

I have used firmware 1.24 for a long time (since release) without issues.
I upgraded to 1.28 yesterday and tried to calibrate the motor kv (its in an e-revo brushless 2200kv) it gave a reading of ~6200kv Twice.
Then I just wanted to run my truck with my friend so I disabled torque control and I noticed that the motor control at start was Terrable.
I went back to 1.24 and it was as smooth as can be.

Any ideas why 1.28 had much worse starts and the torque control calibration was so far off?

We know there is a startup issue and a 'tic' issue (hesitation) when using torque control... We will have a follow-up in about two weeks.

This release was more of a public testing release for the torque control.

We'll have a new release in about two weeks.

Thanx!

Patrick