Another Gmaxx is born

[suicideneil]

Bleh, just been playing with my spurgear collection to see what will fit & mesh- stuck 24/64 on there at the moment but I hate this stupid 3906 slipper mech. So....


27tooth pinion*
HotRacing double-up slipper mech
7075 hard anodized slipper pads ( x2 sets of 3 pads )

I still have the modified input shaft parts from the failed first attempt at using the 3905 spec slipper; with these upgraded slipper parts it should work just fine this time around- no traxxas monkey-metal to fail.

If it is sunny this weekend I think the Madbull will get an outting instead as I have no faith in the slipper on the Gmaxx holding- middle of my 70tooth spur is a bit melted from the carpark video...

*I would normally always get my pinions from Mike, but International shipping rates for just one ~$10 pinion is too much on this occasion..