RC-Monster Forums  

Go Back   RC-Monster Forums > RC-Monster Area > General Discussion

 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
Old
  (#5)
scarletboa
RC-Monster Aluminum
 
scarletboa's Avatar
 
Offline
Posts: 929
Join Date: Mar 2009
Location: Las Vegas NV
01.18.2011, 02:16 AM

i have a 4s 5000mah 45c pack and so far and i am impressed to say the least. in my overgeared (50-55mph) truggy, my 30c packs can get quite toasty and the nano-tech pack only gets a little warm and has crazy punch. i killed a rear diff in my crt-x2 during my first run with the new pack without torque control. the punch difference is immediately noticeable.

the only problem i have seen with my nano-tech pack was during break-in. during the first few cycles, it was pretty out of balance. it was off as much as .2v the first cycle. each cycle has gotten less out of balance and now, it is only off .02-.03 at the most and it is still improving.

another thing i have noticed is all my other turnigy packs get a little spongy after use as soon as the 5th cycle and it slowly get worse each cycle until i would consider it puffed after use. the nano-tech pack has about 10 cycles and no signs of being spongy.


They say a good mechanic only needs 2 tools - WD40 & Duct tape. If it moves, and its not supposed to, duct tape. If it doesn't move, and its supposed to, WD40.
   
Reply With Quote
 


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump







Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com