Picked up a Stampede 4x4!!

[lincpimp]

Yeah, knew it looked familiar. I had a set or true tracks on my old tekno revo.

Pity tekno did not make their setup use the same bearing sizes as the revo driveshafts use. Then we could just buy revo sliders and mod them to length...

Wonder if we could find a hub from somewhere that uses a 6x12 bearing? Then we could use the old maxx sliders with the 6mm axle... I dunno, sounds like alot of work, but 50 bucks for each end on cvds seems a bit steep. I can remember buying a complete set of maxx cvds for less than 40 bucks, and that was all 6.