Picked up a Stampede 4x4!!

[J57ltr]

Originally Posted by lincpimp

1x2 should work. I think the vice will go at least 2". What is the 3rd dimension?

I have 1" in like 4' by 8' sheets, and tons of scrap in about the 12" X 12" size. Most of it is UHMW (Think cutting board material), but it should work fine for a jig. It's 1" thick so whatever dims you want I'll make for you. I'll just cut it up on the bandsaw then mill it flat so it's parallel, just let me know.

Jeff

[lincpimp]

Originally Posted by J57ltr

I have 1" in like 4' by 8' sheets, and tons of scrap in about the 12" X 12" size. Most of it is UHMW (Think cutting board material), but it should work fine for a jig. It's 1" thick so whatever dims you want I'll make for you. I'll just cut it up on the bandsaw then mill it flat so it's parallel, just let me know.

Jeff

Ok, sounds good. I will measure the vice and let you know.