help - xerun 80 on 5s?

[junkman]

I don't know if it applies here, but used to run the 80a ezrun's on 5s, the programming card itself didn't show that as an option, but when you went to the lvc choice it would set up just like the 150a did. It would not be autodetecting, just work on 5s only. I don't know if any of the others work that way or not.

[florianz]

thanks junkman, I'll switch off the lvc.
point no. 12 in the setup of the esc shows cell count, 1 ist autodedect, or you tell the number of cells, but it counts a max. of 4 cells, even that it's the same programming card like the 150a.

edit:
set the lvc of, doesn't work, just green light blinking. so it seems that here have been more changes to the ezrun then just a smaller pcb.
the 80a are underrated, the speedpassion are rated 120a, so that's marketing.
I think I have so sell it...