Something I wanted to run by everyone...

it is a shame you live so far away...i have lots of stuff i could pass over to you.
the postage would be the same as buying it new .
when you get a mill and you want some tips on how to mount...cut etc...pm me and ill help you out.
if you are going to machine stainless steel you will need tungsten cutters, hss wont last very long...and wont last at all if you dont use coolant. a coolant system is a must....
good luck.
chris

[zeropointbug]

I have a few parts sitting around too. Living in Canada, would you want them?

[Chadworkz]

Originally Posted by chrismechanic

it is a shame you live so far away...i have lots of stuff i could pass over to you.
the postage would be the same as buying it new .
when you get a mill and you want some tips on how to mount...cut etc...pm me and ill help you out.
if you are going to machine stainless steel you will need tungsten cutters, hss wont last very long...and wont last at all if you dont use coolant. a coolant system is a must....
good luck.
chris

Cool, thank you so much...I will definetly need help learning!

Originally Posted by zeropointbug

I have a few parts sitting around too. Living in Canada, would you want them?

Sure, incoming PM...