RC-Monster Forums  

Go Back   RC-Monster Forums > Support Forums > General Electric

 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
Old
  (#4)
MetalMan
RC-Monster Mod
 
MetalMan's Avatar
 
Offline
Posts: 5,297
Join Date: Mar 2005
Location: SoCal
07.01.2006, 01:34 PM

Convential balancers don't disconnect the cells that are at a higher voltage. They merely drain current from them to lower the voltage of that cell. The voltage difference cause by this small (120ma) drain is very small, maybe 0.002v (depending on the capacity of the battery). The LBA6 is a convential balancer. The only disconnecting it can do is to disconnect the whole battery when any cell reaches 4.30v when it used between the charger and battery. The way the ICE deals with this is by immediately detecting an open circuit. Other chargers act differently, but usually it isn't a problem.

I haven't heard anything bad about BPP.


SH Z-Car, Custom Crawler, 8s Savage, 12s XTM XLB 1/7 buggy, 4wd 4-link rear/IFS Pro4 truck, Custom Hyper 10 Short Course, Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz
   
Reply With Quote
 


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump







Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com