Supermaxx brushless

[Serum]

that .05mm can't hurt that bad..

You can use a gasket between the two halves, i know Ryan used it for his.

I don't understand you.

Adding a gasket between the halves won't change the width of the case, only the length will increase.

BTW .05mm metal to metal conntact didn't let me fit the case.

[marc993turbo]

Originally Posted by VWT4

I don't understand you.

Adding a gasket between the halves won't change the width of the case, only the length will increase.

BTW .05mm metal to metal conntact didn't let me fit the case.

Hi !

I know what you mean, i tried to install the gear box this night and no, it does not fit.

I am going to buy a milling cutter for my dremel today and cut out the
missing 0,5mm from the braces.

That will not hurt the stability...

Marc.

[coolhandcountry]

Originally Posted by marc993turbo

Hi !

I know what you mean, i tried to install the gear box this night and no, it does not fit.

I am going to buy a milling cutter for my dremel today and cut out the
missing 0,5mm from the braces.

That will not hurt the stability...

Marc.

I think I would use a file first. The dremel is good for larger amounts.
The file is a safer more even cut.

[marc993turbo]

Originally Posted by Serum

that .05mm can't hurt that bad..

You can use a gasket between the two halves, i know Ryan used it for his.

Hi !

I think you are refering to the transmission half cases that don´t fit quite well because they are too short.

You can either use a gasket or dremel a little bit on the input shaft...

I did the second.

Marc.