mamba max brushed

[Serum]

@boss and sylvester;

1600N/mm is 160N/cm.. Ten points go to Leroy..

[GriffinRU]

Originally Posted by jollyjumper

hmmmmm
so how would i convert oz-in to newton-mm then?
thanks.

1 oz = 0.278 N (Force)
1 In = 0.0254 m

Ex. 16 oz-in = 16*0.278*0.0254 = 0.113 Nm

Artur

[coolhandcountry]

.113nm = 113nmm =11.3ncm

[jollyjumper]

okay.
i wanna try something.
need imput.:032:
clods use 2 540 brushed motors.
would the twin force work with 2 540's?
i dont want too much power so it wheelies and stuff like that.
i like to keep the nose on the ground.
would power them with 2s lipo.

[GorillaMaxx360]

Just go Brushless you will be much happier if you get the right setup

[jollyjumper]

cant play alot when the motors cost 300€.:002:
i mean expirement.(spelling:032: )

[GorillaMaxx360]

feiago 85 bucks but dont know how much that is in other money but here that is about the same price a touring car motor that is used in the championship races that pros use.

[pinolelst]

Originally Posted by GorillaMaxx360

feiago 85 bucks but dont know how much that is in other money but here that is about the same price a touring car motor that is used in the championship races that pros use.

Yep..the last 10 turn brushed motor I bought cost me $80 USD :032:

pinolelst

[jollyjumper]

can get decent mod motors for 35€ aswell.

[glassdoctor]

I've been paying $50-60 for handwound mods for like 20 years now... prices haven't changed since the 80's

There are some nice machined wounds for $30-40 too like jolly says.

[jollyjumper]

high-end handwounds go from 85€ to 110€ here.
i was wondering, will mamba handle 2 motors (brushed):032:

[coolhandcountry]

As long as they don't go over the rated amps for it. You good. Depends on
how you wire to. Parrellal and seires has two different amp ratings for same motors.

[jollyjumper]

any one know this motor well?
http://www.plettenberg-motoren.com/U...0_20/motor.htm

[sven]

Originally Posted by jollyjumper

high-end handwounds go from 85€ to 110€ here.
i was wondering, will mamba handle 2 motors (brushed):032:

You could probably run quite a few brushed motors off of the MM. :027:
I use the Mamba Max in my clod crawler, running 2 55t lathe motors in parallel. It is great for that application due to the drag brakes.

[jollyjumper]

one would need a data logger to be sure.
so one can measure amp draw of the motors.
but i'm sure mambamax' wouldnt handle alot more then 2 motors.