|
03.08.2007, 09:54 PM
Last weekend at the track my MM's wires got chewed up very badly by the pinion/spur. Fortunately it doesn't appear/smell like the MM shorted out by the wires touching. I've already replaced the wires, but I'm thinking I will do it over again with some proper 12ga. wire (not sure what the wire is that I put on). I used copper braid to suck up the solder that was in/around the holes to get the new wire in, and then I put solder on the wires (when they were in the holes). Hopefully the Deans Wet Noodle (12ga.) will fit.
SH Z-Car, Custom Crawler, 8s Savage, 12s XTM XLB 1/7 buggy, 4wd 4-link rear/IFS Pro4 truck, Custom Hyper 10 Short Course, Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz
|
Threaded Mode
