B-Maxx project coming to finish

[zeropointbug]

I have not ran my truck yet (if it WERE a truck yet :005: )

I just ordered all the rest of my parts such as FLM chassis, single speed (not from Mike :024: ), Strobe kit, 51T spur, 18T, 15T pinions, stock motor mount, and a few other things for tranny...

Originally I was going to run 6s2p A123, but that would just be 'SICK' :017:

So 5s2p is 'just right' for the 7XL i think. Yes, like Patrick said, it will be a little more powerful under load than on 4s LiPo (typical pack).

It should be pretty good setup anyways, especially with this heatsink I am going to use, I simply won't have to worry about heat issues, EVER! :028:

I am also thinking of some how making a piece of copper that goes over the top FET's and bottom FET's and attaches to the Quark case (one piece). So then the top set of FET's will get much better heat dissipation, furhter making it a monster esc.... that it should have been in the first place! :031:

Cheers!