Turn all of "BATCH 2" MMM up to 6v??

[VintageMA]

Originally Posted by Joe Ford

Actually, we wish we could have put the CC BEC on it as well. There just wasn't enough room though...not enough pins on the processor as I understand it.

No worries - I am willing to accept the trade-off. I am one of the nuts who was running 5S through the original MM with a CCBEC with no problems, but I have to say the 'feel' of the same setup of with the MMM is a much smoother performance in regards to acceleration.

[Joe Ford]

Guys we've discussed doing 6v upgrades for $25. If the controller has an issue though, you have to pay another $25 to get it working if it's the BEC, flat rate repair fee if the controller goes. This would be considered a modification to the controller.

[tc3_racer_001]

i think id rather have the 1 year warrenty!

[TexasSP]

^^^^^^^ I second that one!

[Arct1k]

and perhaps ditch the castle link... to save costs...

How about making it opto via programming as a compromise.... is that doable?

[theJoker]

Just to put a cap on this is looks like there is only moderate interest in 6v for batch 2.

So I withdraw my proposal. and I feel better about 5.5 ....