MetalMan's brushless Revo is at it again...

[MetalMan]

Serum, do you mean these ones?:
http://www2.towerhobbies.com/cgi-bin...gy&FVPROFIL=++

[Serum]

Exactamundo!

They look like the real deal to me.

Moulded foams.. GRP makes good rubber. and i've seen a movie some dudes where banging on them with a big hammer..

after some searching;

http://video.google.co.uk/videoplay?...TJPProductions

[zeropointbug]

Those are nice rims/wheel set. What size hex do they use? Kinda looks like 17mm.

[Gustav]

Originally Posted by Serum

Exactamundo!

They look like the real deal to me.

Moulded foams.. GRP makes good rubber. and i've seen a movie some dudes where banging on them with a big hammer..

after some searching;

http://video.google.co.uk/videoplay?...TJPProductions

Now that's some strange behavoir,the trumpet was nice though.so the GRP is quality gear then,that's good to know.What 17mm adapters do we like for maxxs,revos n' suc h?

[GorillaMaxx360]

they are 17mm nice strong rims

MM, I have to comment again, that the vid was nice. Your truck seems to run very smoothly without any hiccups. That compro looks like it's doing its job, which is a relief to me, since I just ordered one instead of the Quark.

[MetalMan]

Originally Posted by AAngel

MM, I have to comment again, that the vid was nice. Your truck seems to run very smoothly without any hiccups. That compro looks like it's doing its job, which is a relief to me, since I just ordered one instead of the Quark.

I would say it runs pretty well. Even though it's the version without heastinks (it's wrapped in heatshrink with only heat spreaders), it runs at a pretty good temperature. In the same truck the MM needed a fan to keep it from thermalling. One problem with this ESC is that the BEC chip burnt out, and so now it sends the main battery's voltage to the receiver. When that happened, it smoked the receiver and servo... But with a RX pack it runs just fine. I might take the shrinkwrap off and add heatsinks to it to make it run even cooler.

Nie truck Metal Man. That thing moves!

Those GRP wheels are crazy...

[squeeforever]

The Ofna's are probably your best bet, unless you wanna go with the RD Racing knuckles w/8mm axle kit and run buggy hubs.

[Romster]

Metal man nice video and nice weet set-up!!
Love the Jumps!!

[Romster]

Sweet set-up!

[neweuser]

Very nice MetalMan. I really like your Revo. The MGM is it? Seems to do very well! I likes!

[MetalMan]

Yeah, it's the MGM that arrived at my door as a replacement for one I sent in 6 months before I got this one!

[BP-Revo]

Looks fun...can't wait until my G2R is ready. I'm sending the X-Braces into George for a free replacement tomorrow. :D

[MetalMan]

Will you be joining me for some back-flipping fun? :) I think you might enjoy it :027:.