3.3 drivetrain for E-Maxx

[neweuser]

Originally Posted by TruckBasher

i thought so.....i was thinking maybe there is a way to fit it....drilling would make it weak....anyway maybe i could try it sometime.....

You could use Serums idea, it works well from what I hear. I personally know a guy that has done this with great success, but he only runs the HV maxx set up too.

[ssspconcepts]

Originally Posted by Procharged5.0

They look awesome in the ads. Having the dust boots is a godsend in my opinion. That's the downside to any CVD typically.

Hey, I haven't seen any ads for the new maxx drive shafts...do you have a link to them? Thanks.

[Serum]

http://www.rc-monster.com/forum/showthread.php?t=4993

http://www.rc-monster.com/forum/showthread.php?t=4988

There they are!

[ssspconcepts]

Originally Posted by Serum

http://www.rc-monster.com/forum/showthread.php?t=4993

http://www.rc-monster.com/forum/showthread.php?t=4988

There they are!

Thanks. I am new to the whole monster truck thing...but been in the RC hobby since mid 80s. Mostly I run Losi XXXT MF2 and RC18Ts. But just recently I sais to heck with it and ordered an e-maxx and the FLM chassis kit. This is where I am in the build.

[SpeedAssault]

I have researching like crazy for MONTHS, for something to replace my revo plastic shafts. But in the end Revo stock shafts look to be the best, cheap overall shaft, EXCEPT for the NEW Traxxas SUMMIT shafts, Now they are the bomb ! but expensive.

I am running a custom made 1/5 4wd street missile on 6S.
My Revo's are holding well so far after 3 runs, I have done some Full throtle starts from dead stop where the car actually jumped inthe air and landed onit's side. the plastic joints show a very small sign of stretch, very small

only broken one shaft so far with Locked up Front and rear diffs and center tranny.