Problems programming my BK controller

I just picked up a brushless revo and I'm having trouble programming the BK controller that came with it. I found the thread on this site (http://www.rc-monster.com/forum/show...?s=&threadid=8) that shows the steps for programming the controller but I can't seem to get it to work properly...there is no beep from the motor when I turn everything on??

In the part where it says "remove the red programming bridge (little red jumper near the battery leads)." is that referring to the little red wire that is shown in the attached picture that comes from the battery lead?

Any help would be greatly appreciated as I would love to get this thing going