RC-Monster Forums  

Go Back   RC-Monster Forums > Search Forums
Reload this Page Search Results

Showing results 1 to 13 of 13
Search took 0.00 seconds. Search: Posts Made By: SilveradoHD
Forum: Castle Creations 11.18.2008, 12:07 AM
Replies: 7
Views: 3,264
Posted By SilveradoHD
I have ran two 5s packs through my v3 in my Mugen...

I have ran two 5s packs through my v3 in my Mugen MBX4 conversion and so far it is holding up. I have 100% punch control, 8 motor timing, low start power, and this baby will still make the buggy...
Forum: Castle Creations 10.22.2008, 05:23 PM
Replies: 17
Views: 5,521
Posted By SilveradoHD
Well I had some extra time today so I unsoldered...

Well I had some extra time today so I unsoldered all my 5.5mm bullets, and direct soldered the castle wires to a known working Medusa 3300kv. Plugged it in, powered it up, and still the same...
Forum: Castle Creations 10.18.2008, 06:11 PM
Replies: 17
Views: 5,521
Posted By SilveradoHD
It is not in brushed mode, I just checked. I...

It is not in brushed mode, I just checked. I checked over all the wires today and they look fine. I tried another receiver, still no luck. I am going from the 6.5mm bullets at the speed controller...
Forum: Castle Creations 10.18.2008, 01:10 AM
Replies: 17
Views: 5,521
Posted By SilveradoHD
I am pretty sure its all connected from briefly...

I am pretty sure its all connected from briefly checking it over, but will check again tommorow. Even if it was missing 1 phase, shouldn't it still cog and try to go? And if the problem was in the...
Forum: Castle Creations 10.17.2008, 08:36 PM
Replies: 17
Views: 5,521
Posted By SilveradoHD
old school Futaba 3PJS

old school Futaba 3PJS
Forum: Castle Creations 10.17.2008, 07:29 PM
Replies: 17
Views: 5,521
Posted By SilveradoHD
It is recognized by Castle Link. I re calibrated...

It is recognized by Castle Link. I re calibrated it to my radio. It now turns green, yellow and red when moving the trigger but still no power. There is also no audible tone anymore. I put an old...
Forum: Castle Creations 10.17.2008, 06:42 PM
Replies: 17
Views: 5,521
Posted By SilveradoHD
Is this a dead MMM?

I just finished up my Mugen XR conversion using a MMM v2, Medusa 2000kv, and a 5s Zippy lipo. Took her out just now and after a high speed pass the buggy locked up and would not go again. The...
Forum: Buggy 10.17.2008, 12:13 AM
Replies: 4
Views: 8,959
Posted By SilveradoHD
Got all the parts in today for my MBX4-XR...

Got all the parts in today for my MBX4-XR conversion and hit a few snags. The RC-Monster Mugen motor mount fits, but it is a tad too short. The older MBX4 diff sits about 2mm higher. This causes...
Forum: Brushless 10.11.2008, 12:40 AM
Replies: 59
Views: 10,701
Posted By SilveradoHD
I already had the 5s ordered, should I cancel and...

I already had the 5s ordered, should I cancel and go with a 4s instead, or would the 5s be dandy with the 2000kv medusa on a 13t or 16t pinion?
Forum: Brushless 10.10.2008, 03:22 PM
Replies: 607
Views: 143,744
Posted By SilveradoHD
Would the 2000kv 60mm Medusa run fine on a 5s in...

Would the 2000kv 60mm Medusa run fine on a 5s in an 8th scale buggy conversion. I just ordered one along with a 5s with 16t and 13t pinions. This should be well under the 60,000 rpm limit. Should...
Forum: Brushless 10.10.2008, 12:57 PM
Replies: 59
Views: 10,701
Posted By SilveradoHD
I am about to order the parts right now to...

I am about to order the parts right now to convert my MBX4-XR. I will be running a Medusa 2000kv with a MMM ESC and a Airtronics 358 servo. I will be using the cheap zippy packs. My question is,...
Forum: Buggy 10.01.2008, 10:23 PM
Replies: 4
Views: 8,959
Posted By SilveradoHD
Awesome, after converting my Rustler to a drag...

Awesome, after converting my Rustler to a drag racer I have an itching for a reliable basher and I think my old MBX4-XR would do the trick. I know parts are getting hard to find but nitrohouse.com...
Forum: Buggy 10.01.2008, 05:14 PM
Replies: 4
Views: 8,959
Posted By SilveradoHD
Mugen MBX4-XR Conversion?

I have an old Mugen MBX4-XR and another parts buggy in need of a powerplant. I am looking to convert it to brushless. I was wondering if the RC Monster motor mount for mugen will fit in the MBX4XR...
Showing results 1 to 13 of 13

 
Forum Jump






Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com

Contact Us - RC-Monster Store - Archive - Top