RC-Monster Forums  

Go Back   RC-Monster Forums > Search Forums
Reload this Page Search Results

Page 1 of 4 1 23 Last »
Showing results 1 to 25 of 93
Search took 0.01 seconds. Search: Posts Made By: transtalon
Forum: Brushless 09.16.2011, 08:33 AM
Replies: 21
Views: 19,516
Posted By transtalon
No I sold it offshore forum for 240 shipped with...

No I sold it offshore forum for 240 shipped with the watercooling jacket. Never heard back from him after that. I guess the motor worked out for his application. But this motor should be a beast on...
Forum: Brushless 09.15.2011, 06:49 PM
Replies: 21
Views: 19,516
Posted By transtalon
I lost interest with that motor as I was having...

I lost interest with that motor as I was having about a couple of good runs and then the ESC burst into flames. It could be the battery Maxamps that I used to run (first battery) POS. But i believe I...
Forum: Brushless 09.15.2011, 04:58 PM
Replies: 21
Views: 19,516
Posted By transtalon
The 1527 1D motor is an amp hog. I don't think...

The 1527 1D motor is an amp hog. I don't think the MMM will be able to handle the amount of power (amp) that this motor needs. The only way I ran this motor was with the Hydra240 with a fully...
Forum: Brushless 09.15.2011, 07:53 AM
Replies: 21
Views: 19,516
Posted By transtalon
That 1527 1D will not work with the MMM as it is...

That 1527 1D will not work with the MMM as it is a beast. I use to own these and it will smoke the Hydra 240. This is just a hard motor for esc and batteries in my opinion. The boat guys love that...
Forum: Castle Creations 10.12.2010, 09:43 PM
Replies: 559
Views: 152,448
Posted By transtalon
Got the rest of my 1717 (2X) car version today. I...

Got the rest of my 1717 (2X) car version today. I am very pleased with the quality of Castle Products. Thanks again for correcting the motors.
Forum: Castle Creations 10.08.2010, 02:22 PM
Replies: 559
Views: 152,448
Posted By transtalon
I had a total of 1717 Air version and all have...

I had a total of 1717 Air version and all have the 6mm shaft and the car has 5 mm shaft. Just letting you guys know that it will be a problem for the pinion selection for the Air version. Just email...
Forum: Castle Creations 10.07.2010, 08:26 AM
Replies: 559
Views: 152,448
Posted By transtalon
Just let them know either by calling or email and...

Just let them know either by calling or email and they will send you a shipping label to send the wrong one back free of charges. Also today they are going through all the boxes and verifying that...
Forum: Castle Creations 10.06.2010, 06:55 PM
Replies: 559
Views: 152,448
Posted By transtalon
Just to add more to this thread. I ordered my one...

Just to add more to this thread. I ordered my one 1717 and one 1520 when they the clearance on two Fridays ago. Following Monday, I changed my order to 3 1717 car version instead of the previous...
Forum: Castle Creations 09.12.2010, 10:17 PM
Replies: 4
Views: 2,560
Posted By transtalon
M18

That is some serious speed for an 18th scale. I do have one of those and extended it to fit a 3S but it keep on steering to the right. It was fast but just don't have a smooth road like you do. Great...
Forum: Brushless 06.24.2010, 11:10 PM
Replies: 213
Views: 98,698
Posted By transtalon
muggy

You should weld the ends with a stainless steel hollow tubing. I had one with a brazed weld and it broke off. I had one tig welded and I never had problem with it. You can also mig weld it if you...
Forum: General Discussion 12.16.2009, 09:25 AM
Replies: 25
Views: 7,924
Posted By transtalon
dual lock

They have that available at Hobos in pieces. I think I paid 5.00 for like 50 pieces instead of 3.99 for only 4 pcs at Target.
Forum: Truggy 11.25.2009, 12:51 AM
Replies: 63
Views: 20,130
Posted By transtalon
Mbx5t

Thanks for the positive input.:smile:
Forum: Truggy 11.24.2009, 08:08 PM
Replies: 63
Views: 20,130
Posted By transtalon
Mbx5t

Were you having problems with the pin inside the side of the spider gears. The one that goes in the outdrive. I find it to be smaller than the similar buggy or truggy pins. Did you ever break one of...
Forum: Brushless 09.01.2009, 11:28 PM
Replies: 15
Views: 6,017
Posted By transtalon
offset

I know based on my buggy which is built for top speed that with the extended wheel hex it was more stable at high speed and it sure does not rollover like before. I am running a 43spur/25 pinion, 80...
Forum: Brushless 08.20.2009, 08:48 AM
Replies: 638
Views: 154,831
Posted By transtalon
fans

I think that fan is a great idea but it would not be enough to cool down the aluminum plates as when the esc heats up, it heats up real fast. It really needs a watercooling to have the 240 amp rating...
Forum: Brushless 07.25.2009, 10:21 AM
Replies: 638
Views: 154,831
Posted By transtalon
watercooling

The links for the water reservoir looks tricked out. I think this is all you need and the pump that they are selling. The TCS pump is small and looks real good. But it works good as long as you don't...
Forum: Brushless 07.24.2009, 08:22 PM
Replies: 638
Views: 154,831
Posted By transtalon
watercooling

I use the watercooling setup with my Hydra 240 and Neu 1527 1D and without the working water pump and a home made radiator similar to the picture up top it made my temps to drop from 170 degrees to...
Forum: General Discussion 06.08.2009, 07:27 PM
Replies: 2
Views: 2,948
Posted By transtalon
tires

I think this is for a 1/10 scale cars. They only made belted tires for the buggy size.
Forum: Brushless 06.07.2009, 11:56 AM
Replies: 19
Views: 3,806
Posted By transtalon
Neu

No it's not coming out of the motor but your ESC will burst into flames. I was running a 5S setup with that motor with 30 pinion and 63 spur on a heavy extended Lst2 17 lbs everything was okay but...
Forum: Brushless 06.06.2009, 11:53 PM
Replies: 19
Views: 3,806
Posted By transtalon
1527

I also have that motor on my conversion. Be prepare to put out the flames after a couple of minutes. The motor is an amp hungry and I was running on 6S, I think the MMM won't handle the continous...
Forum: Brushless 06.06.2009, 04:47 PM
Replies: 1
Views: 2,717
Posted By transtalon
glitchy

I have a Nomadio Sensor and I accidentally pinch the antenna cable and it began to develop a glitch. I was showing it off with my friend and the buggy is capable of 70+mph and it lost connection with...
Forum: Castle Creations 06.06.2009, 04:37 PM
Replies: 3
Views: 2,251
Posted By transtalon
Montster replacement

I just got a replacement from Castle and their excellent customer service and I notice that the brakes are much smoother and doesn't lockup like before. Also it is smoother on takeoff in the low...
Forum: Brushless 06.06.2009, 04:30 PM
Replies: 96
Views: 17,649
Posted By transtalon
lipo

I agree with lincpimp. I have the Polyrc 4350 and it was taking close to 4200 when I charge it one time. I think Polyrc is not a popular name like Polyquest or Flightpower but they are real good and...
Forum: Brushless 06.06.2009, 11:15 AM
Replies: 96
Views: 17,649
Posted By transtalon
lipo

This pack started out as a 6S 8400 25C cell according to Josh. I received it and it sit for three weeks while I wait for my Hydra 240 and I checked the voltage on each cell and one of the cell was...
Forum: Brushless 06.06.2009, 12:53 AM
Replies: 96
Views: 17,649
Posted By transtalon
Maxxamps batt always out of balance

I was getting tired of this 3S 8000 MAH 25C cell that I got from Maxamps from being out of balance everytime I run it and I decided to open it up. I found that there is a pair of 4200 MAH 25C cell...
Showing results 1 to 25 of 93
Page 1 of 4 1 23 Last »

 
Forum Jump






Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com

Contact Us - RC-Monster Store - Archive - Top