ALZA racing Flux Baja 5b

[Aero]

Loking great knez! and for this special sunday:

I wouldnt mind all that copycat/bashcat talk. Integy parts ? Hm isn't that a rip off of the original HPI steering rack ? JK. Weights ?

Alza racing is probably the better dealer, awesome shipping too. Hoped I could have some 5mm CF tvp's but turns out he's okay with custom tvp's (in 5mm alu)

btw those FLM arms, whats the diff between FLM41500 and 41510, everything's the same, even the price and 20013.jpg picture ? i suppose the 41500 are 9x123mm dogbones, and 41510 11x123mm ?

the dogbones from alza, are they steel ? howcome you ordered flm drive shafts, and then be gettin the arms from alza ?

[Knez]

Jah, yes i tested the integy hubs and diference between them and stock is like night and day. I am never using stock again.

Erghh i do agree, to use Dejan for a wing would be a bit dificult,lol, hmmm, maybe he could just cut something out. I want to use baja roll cage at the end anyway.


Hi Aero :) Well integy hubs did cost, was like 95$ + tax.
Must say these do solve a lot of small "problems", like gap between the hubs, better turning. Now it is all nice and tight.

Alza is a great shop and he is a great guy, i know :)
That is why i buy there everything i need. Waiting for XL arms for FLM dogbones.

On FLM site they say both kits are Extended.... dont know what is the diference.

Alza dogbones are stainless steel. I ordered FLM dogbones as price is good.
Arms will do alza as this way i get them a lot cheaper..i also dont pay tax this way.



Small update: Foty had head on chrash.
-Broken front bulk
-Twisted braces, one in bulk and lower one that holds skids
-Broken Diff output pins
-Broken gears
-Cracked diff cup
-Diff screw broken

here few pic.





Not finished HPI product:





All this is now fixed and hes 5b is rtr again. We also changed oil in hes diffs.
50W front 30W back. And foty has 23/44T gearing, dont know why i thought he got 20/44T.

Because of motor pinion screw always going lose, i mounted hes motor pinion with M4 screw M4x6mm for 23T m. pinion. Pinion is turned other way around and secured.




I only turned my sevo for 90 degrees and cutted the body, now it sits nicer.







I am having problems with slipper screw. It is getting lose and my 44T diataches from slipper kit. Will try to use 2 nuts and red locktite. Hope this will hold.

[Knez]

Here a new BMX track...had a taste today for 30min than lower part from shocks broke...

Video : http://www.youtube.com/watch?v=nAOC-rJNvFk









Also removed all shims from slipper kit and used M5 slim nut so it goes to the shaft "on the part that is got no thread for screw" and pushes 44T properly on the slipper kit. Tighten it with stock M4 nut and used another "slim" nut over the stock. A lots of lock tight, 24hr healed.

[Bmr4life]

Were you running 4wd?