RC-Monster Forums  

Go Back   RC-Monster Forums > Support Forums > Brushless

 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
Old
  (#32)
Buzzsaw46
Guest
 
Posts: n/a
04.04.2008, 03:01 PM

I bought a 36-50-3300 for my HPI NMT, but it has ended up in my E-maxx for the moment.

Performance is good in the maxx on a 5s2p A123,13/68 gears(3905 tranny). About mid 30's for top speed, wheelies up to about 10-15mph. With a novak HV heat sink it was running 120f after about an 8 min run. Without the heat sink I was hitting 170-180 in about 6-7 min. On a 15t pinion it was up in the 40mph range, lifting the front end into the 20mph range. I havent ran the 15t since I put the heat sink on but it was up close to 200f after a 9 min run.

I seized the front bearing after about a dozen runs, but for the price($35) I'm very pleased with the motor so far.

Gee, Medusa has a 36-50-4800. I have a 36-50-3300 Medusa on the way and an Eagle tree micro logger ready to go. I hope to have some good graphs of the Ammo Vs. the Medusa this weekend..
   
Reply With Quote
 


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump







Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com