wut to replace the stock slipper?

[Shadow350Z]

as the title says

wut do i replace the stock 70T slipper with?

[RC-Monster Mike]

I recommend the Strobe slipper as a replacement/upgrade. It takes bigger, tougher gears and has the ability to dial in some slip, unlike the stock setup.

[Shadow350Z]

thnx Mike
can i get a linky??
to the best and not a wallet burner

[Serum]

http://www.rc-monster.com/proddetail...od=Slipper-Kit

It includes the bearing.

[coolhandcountry]

If you go to the strobe. Don't you have to change the pitch to mod 1?

[Serum]

Yeah, that's the reason why Mike reccomends it.. Mod 1 is much stronger than a 32 ptich..

[coolhandcountry]

The strength part sounds real good. Just seems the selection of spurs are limited. I still running the 32 pitch for this reason. I have to change up. ONe day.

[Shadow350Z]

so means i need to change pinions too?
wut pinions should i use??
that i can get at my LHS also can fit a HV-MAxx

[Serum]

You probably can't get them at your lhs, it are mod 1 pinions.

[mt_enthusiast]

I ran the 1/8" mod1 pinions from Mike with the 51T Ofna spur on the HV-Maxx. You really need to watch the final gear ratio recommended by Novak. Before replacing the HV-Maxx, I originally geared 1st speed to be in the recommended gear ratio and never used 2nd.

[Shadow350Z]

will robinson racing double disc be good replacement??

[coolhandcountry]

The robinson does nicely. IT is not the strobe system. It does run the 32 pitch though.

[Shadow350Z]

so how doe the robinson work??
does it stil use sliper pegs?

[coolhandcountry]

No slipper pegs. It uses disk. Hold alot better than pegs.

[RC-Monster Mike]

The Robinson is a step above the stock setup, but a couple steps below the Strobe. With high power, the Robinson slipper is inconsistant, and the spur gears are rather soft. The Strobe offers more durability, consistency and tuneability.