Quote:
Originally Posted by redshift
Brian, you should re-read my post :)
With Dean's micros, it doesn't matter if the one exposed term is pos or neg, I just wondered if there was a standard for load side/batt side, I think maybe not?
Reason I'd like to know is I'll have 4 pairs in close proximity to themselves, I'd just like to know so I can do all 4 the same in attempt to prevent an oops with crossing packs (am running 2x2S with 2 Deans micros running off each pack)
I shoulda been a bit more specific, I didn't wanna start a thread for this ;) so I just picked the newest "connector" thread...
|
Even if the pos on one pack touched the neg on another nothing would happen (still an open circuit). But you still want them to all be the same so you don't mess up your esc.
Threaded Mode
