Need response from a Castle tech for MMM question

[joeling]

Can I nominate this to be a sticky ? BrianG is a legend. I have just done this mod to my dead V1 & magically, the esc has been resurrected.


Before


After

Regards,
Joe Ling

[BrianG]

Originally Posted by joeling

Can I nominate this to be a sticky ? BrianG is a legend. I have just done this mod to my dead V1 & magically, the esc has been resurrected.

Don't forget to remove the switch wires and bridge the solder pads where the switch goes. I did a little more testing with the switch in place and found that when it was off and ran it for a couple of minutes, I'd have odd performance. Something like cogging, but not. With the switch closed, everything runs perfectly. So, you might as well remove it and bridge the pads. Cleans up the wiring too.

[joeling]

Yep, curious me already tried that. Not good to have the switch opened.

Thanks.

Originally Posted by BrianG

Don't forget to remove the switch wires and bridge the solder pads where the switch goes. I did a little more testing with the switch in place and found that when it was off and ran it for a couple of minutes, I'd have odd performance. Something like cogging, but not. With the switch closed, everything runs perfectly. So, you might as well remove it and bridge the pads. Cleans up the wiring too.

Regards,
Joe Ling