Batch 2 V2 MMM

[xtremelimits285]

Just got my v2 MMM yesterday!!!

Thanks Mike....

Should i direct solder mine, or do i need to get 6.5mm bullets? my MMM didnt come with any male bullets, the MMM HAS female 6.5mm bullets installed on the MMM, but no males???

It came with 3 motor wires 6" long, an 2 battery wires 6" long, stickers, a cd, a usb wire and chip to plug the MMM to the usb, but there isnt any bullet plugs...

My hobby shop has 4mm bullets , but no 6.5mm bullets, will the 4mm bullets work to conect the motor to the esc wires?

I read some post that said only 6.5mm or dirct solder is to be used/done on the MMM...

[JThiessen]

Originally Posted by xtremelimits285

Just got my v2 MMM yesterday!!!

Thanks Mike....

Should i direct solder mine, or do i need to get 6.5mm bullets? my MMM didnt come with any male bullets, the MMM HAS female 6.5mm bullets installed on the MMM, but no males???

It came with 3 motor wires 6" long, an 2 battery wires 6" long, stickers, a cd, a usb wire and chip to plug the MMM to the usb, but there isnt any bullet plugs...

My hobby shop has 4mm bullets , but no 6.5mm bullets, will the 4mm bullets work to conect the motor to the esc wires?

I read some post that said only 6.5mm or dirct solder is to be used/done on the MMM...

The wire's don't have male bullets on them on one end? Mine did, and the only thing I had to solder was my choice of ends to connect the motor (I used 6mm bullets for that). I did attempt to use 4mm, but the wire wouldn't fit into the socket on the bullet.

[JeffEmbracedDC]

Originally Posted by JThiessen

The wire's don't have male bullets on them on one end? Mine did, and the only thing I had to solder was my choice of ends to connect the motor (I used 6mm bullets for that). I did attempt to use 4mm, but the wire wouldn't fit into the socket on the bullet.

As did all of mine..

[xtremelimits285]

Originally Posted by JThiessen

The wire's don't have male bullets on them on one end? Mine did, and the only thing I had to solder was my choice of ends to connect the motor (I used 6mm bullets for that). I did attempt to use 4mm, but the wire wouldn't fit into the socket on the bullet.

Originally Posted by JeffEmbracedDC

As did all of mine..

no theres no males soldered on any of the wires, both sides of the wires are tinned..

i tryed a set of 4mm's an crap is the tinned solder hard to melt, i had a friend try to put on the 4mm's and no luck, my 80-120watt gun needed a new tip, try or 30mins..

ill just get some 6mm's or 6.5mm's and have the hobby shop down the road put them on, as it probley only takes the 5mis..

im going to use 2 screews to hold down my MMM to my RCPD top plate
and also use 2 zipties just incase...