Muggy diffs in a maxx

[_paralyzed_]

Originally Posted by its me

Hahaha funny you said that, the gearing right now should be about 75MPH but im diffing out really hardcore.. I got 7K in the center :)

I was just bliping the throttle, thinking about running 22t pinions.

Thicken up that center! Get the thickest you can get, a "locker" lube if you can. Oh, and more video

[SnoopMaxx]

Awesome.. I love when he says "That was coooaall "

[Emaxx_Quebec]

What is the best to use to be closest to stock maxx diff

1. Raminator
2. Aftershock
3. LST
4. LST2
5. Mayhem

What the gear ratio of those diffs?
Thanks

[lincpimp]

Originally Posted by Emaxx_Quebec

What is the best to use to be closest to stock maxx diff

1. Raminator
2. Aftershock
3. LST
4. LST2
5. Mayhem

What the gear ratio of those diffs?
Thanks

1st 4 you listed are all the same, 13/43 ratio. Not sure about the mayhem.

[Emaxx_Quebec]

Thanks
So the only diference is the case. ( plastic vs silver alu vs blue alu)

[Emaxx_Quebec]

question about the lst 2 diff convertion
do my traxxas driveshaft and center cvd can be use whit this convertion
a got a 3905 maxx

You'll need to purchase the adapters mike sells, here
. those will go in place of the normal outputs for the left and right. so if you replace both diffs you'll need 4 of those units.

So Ok for the 4 corners.
BUT for the center??
I use

Can I bore ( drill) them out to 8mm.
Or do I need something else like 2 of

If so, how do i connect them to the CVD.
Thanks.

[SnoopMaxx]

You need a set of these 1/8 diff output shaft

Use these 6mm output shafts to replace the stock output shaft/drive cup on most 1/8 diffs. Allows use of stock driveshafts for Maxx and Revo trucks while using 1/8 diffs. 2 required per differential.

You can also make them from Revo spindles