Brushless Cen Genesis

[Arct1k]

You'll need to go to 4mm but I can make those spacers for you...

[xleonex]

you can thier two diffrent size spacers...if isent the spacers and side plates can someone cnc them?

[Hardstyle]

Originally Posted by Arct1k

You'll need to go to 4mm but I can make those spacers for you...

For me? Thanks, but I think I could do 'em by myself. I have some aluminium tubing here somewhere. Just have to take accurate measures and use some hacksaw. Can't be hard Finding a place for it from tvp's is a another story...
I meant that don't have equipments to do any complicated parts..


I still haven't make an order for Mike. Damn! Im missing the most important things. Elecs.
I have thought about 6-8s setup. Medusa 80mm 1100 kv with mmm or lt-10s controller. Don't know if lutach still sells them. Or should I wait till ccneu 1500kv motor? Lipos don't have a clue.. Opinions, suggestions? Im open minded

[93firebird]

Well my work may not be as neat and clean as everyone else but here are some pics of what I have so far. I plan on keeping the stock tranny for now. Does anyone have any suggestions on a gear selection for this setup. I am planning on using a mmm with the neu 2200kv motor running off of a 4s 4000mah battery. I have seen the two speed adapter in the rc-monster store site, but I think that it is set up backwards for this application. Should I just order the gears that fit it opposite for what they are listed as, and are the gears that fit it the proper pitch? I am looking to achieve about 35-45 mph.