Which 17mm hex conversion for E-Maxx?

[skellyo]

Small update on this...

Bought the MIP1665's, stock 3.3 Knuckles and Ofna hexes. I put them on one corner and found out that the 3.3 knuckles pull the CVD's out slightly farther than the 2.5 setup with the UE CVD's. Because of this, the MIP CVD's are slightly too short for the UE outdrives. I decided I didn't want to tear down the whole front and rear diffs to install stubs and the MIP cups, so I bought some custom 17mm hexes for the UE CVD's. I got them in yesterday and hope to have them installed over the weekend.