2650 kv bearing size ???

[prhess]

Hello,

I swapped out all the bearings in my 2650 and 2200 for ceramics from Boca. The rear cover does come off, but when I did the epoxy pulled off some electrical tape that is wrapped around the wires coming out of the motor. I easily added some new insluation (shoe goo) and off I went.


Motor is very smooth, and very cool.

I used these from boca.
http://www.bocabearings.com/main1.as...MR625C-YUU_NB2

I will post pics tonight

I was also curious, what sized bearing do we need to replace the Tork Flux motor ones?

[MetalMan]

Originally Posted by Freezebyte

I was also curious, what sized bearing do we need to replace the Tork Flux motor ones?

It will be the same. The Tork motor is a CC2200 with a different can.

Originally Posted by MetalMan

It will be the same. The Tork motor is a CC2200 with a different can.

Which is what?

[prhess]

Originally Posted by Freezebyte

Which is what?

The tork 2200kv is the same motor as the neu castle 2200kv, but is black instead of green

Originally Posted by prhess

The tork 2200kv is the same motor as the neu castle 2200kv, but is black instead of green

Arrrrgh, I meant what size are the dumb bearings!!!

[prhess]

5x16x5

5mm - inside diameter
16mm - outside diameter
5mm - thickness

I know this for sure as I have replaced my castle-neus bearings. The front and rear are the same size.

[prhess]

I am assuming that they run they 5x16x5 bearing as well.