How are the Rx8 & T8's holding up?

[tedo]

I bit of good news.

Mine runs great with the new rotor. I have been racing it for the past 2 1/2 - 3 months with no hiccups. Absolutely recommend Tekin and Ty. Got my rotors with-in days, so I could race the weekend. The best system by far.

MBX6T
2000 KV combo
Slipperential (a must in my opinion)
46:16
Avid Bearings
Various 4S set-ups (currently loving the Hyperion G3s - wish I had more)
No drag brake
Very, very little brake dialed in (still will stop on a dime). ABS set on my TX.
Low current limiter setting (currently LED #4)
Throttle Profile #2
Higher Nuetral width setting (currently LED 7)
8 degrees timing (might drop it to 0 to squeak out another minute or so)
100% expo on my TX.

[Snipin_Willy]

I'm not sure if I have the old style rotor or the newer fixed type but I just went out to test my freshly installed bearings in my tekin 4030 and my magnets started spinning on the rotor
And I thought I'd get to race by buggy tomorrow, guess I'd be running my trug.
Someone mind PMing the address I need to send this thing to?

[brushlessboy16]

Originally Posted by Snipin_Willy

I'm not sure if I have the old style rotor or the newer fixed type but I just went out to test my freshly installed bearings in my tekin 4030 and my magnets started spinning on the rotor
And I thought I'd get to race by buggy tomorrow, guess I'd be running my trug.
Someone mind PMing the address I need to send this thing to?

You can fix it. Loctite 409, 2 part epoxy- hell I have fixed a feigao motor with strait Medium CA

you can do do it.



As for me, I have tried the rx8 on

CC 2200
CC 2650
Aveox of unknown denomination

When it last went up it want all spiteful and took out my castle motor.

the day after it detonated my tekin t8 1900 buggy motor came in.... which is currently running on a Mamba max while my rx8 is getting re placed.


Irony