 |
|
|
|
|
|
 |
 |
Medusa Bearing Replacements |
 |
|
 |
|
(#1)
|
|
RC-Monster Brushless
Offline
Posts: 2,085
Join Date: Sep 2007
|
Medusa Bearing Replacements -
01.30.2010, 11:57 PM
I've got some really good service from my 36-70-2000kv.
Recently being ran in an E Revo geared 14/52 on 6S. Incredible Power! It was pulled out to try another setup, when I noticed it didn't feel right while spinning it by hand. After running it at low rpm, it's clear that it has a bad bearing. The bearings are 5x13x4mm in size. How well would these work as replacements? http://www3.towerhobbies.com/cgi-bin...?&I=LXFKK6&P=7 Any suggestions would be appreciated. |
|
|
|
 |
 |
 |
|
|
|
|
|
|
(#2)
|
|
RC-Monster Dual Brushless
Offline
Posts: 4,236
Join Date: Dec 2007
Location: Cape Cod, Mass.
|
01.31.2010, 12:13 AM
You could always send it to Neu for replacement bearings. In answer to your question. I personally believe that better bearings make a difference. I replaced a set of diff bearings w/cheap ones and they did not last.
2. MBX-5T 1520, MMM ON 5S 3. MBX-5 ONROAD CONVERSION 1515, MMM ON 5S 4. MRX-3 ON ROAD CONVERSION 1512, MMM ON 6S 5. TEN T 2650 T8, MMP ON 3S |
|
|
|
|
|
|
|
|
|
|
|
|
(#3)
|
|
Soldermaster Extraordinaire
Offline
Posts: 4,529
Join Date: Apr 2007
Location: Plymouth, MA, USA
|
01.31.2010, 12:28 AM
|
|
|
|
|
|
|
|
|
|
|
|
|
(#4)
|
|
RC-Monster Aluminum
Offline
Posts: 503
Join Date: Mar 2007
Location: Algonquin, IL
|
01.31.2010, 02:41 PM
if u email neu u can get just the bearings from them and install them yourself, the are pretty cheap. i inquired on this for another motor i had sometime back
medusa 36-80-2000kv 6s turnigy 30c MMMV3 46ts/ 14-16p spektrum radio |
  |
|
|
|
|
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Linear Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
